pzem004t

An embedded-hal driver for the PZEM004T energy monitor.

A CLI for the library is available and can be run on all major operating systems (uses serialport crate).

Examples

Examples can be found in the examples/ directory.

Read the measurements off the sensor every second

let mut pzem = pzem004t::Pzem::new(serial, None).unwrap();
let mut m = pzem004t::Measurement::default();
loop {
    match pzem.read(&mut m, Some((&mut tim, TIMEOUT))) {
        Err(e) => hprintln!("Could not read PZEM004T: {}", e).unwrap(),
        Ok(()) => {
            hprintln!("Voltage: {:.1} V", m.voltage).unwrap();
            hprintln!("Current: {:.3} A", m.current).unwrap();
            hprintln!("Power: {:.1} W", m.power).unwrap();
            hprintln!("Energy: {:.3} kWh", m.energy).unwrap();
            hprintln!("Frequency: {:.1} Hz", m.frequency).unwrap();
            hprintln!("Power factor: {:.2}", m.pf).unwrap();
            hprintln!("Alarm: {}\n", m.alarm).unwrap();
        }
    }

    tim.start(1.hz());
    block!(tim.wait()).unwrap();
}

License

This project is licensed under either of

• Apache License, Version 2.0, (LICENSE-APACHE or http://www.apache.org/licenses/LICENSE-2.0)
• MIT license (LICENSE-MIT or http://opensource.org/licenses/MIT)

at your option.

Contribution

Unless you explicitly state otherwise, any contribution intentionally submitted for inclusion in hexi by you, as defined in the Apache-2.0 license, shall be dual licensed as above, without any additional terms or conditions.