TMP108

A #[no_std] platform-agnostic driver for the TMP108 temperature sensor using the embedded-hal traits.

The TMP108 can take one of 4 I2C addresses depending on the state of the A0 pin, as described in the table below:

The driver has specific constructors for each of these states, to ensure that an invalid address is not attempted.

Usage

let delay = DelayNs;
let mut tmp = Tmp108::new_with_a0_gnd(i2c, delay);
// let mut tmp = Tmp108::new_with_a0_vplus(i2c, delay);
// let mut tmp = Tmp108::new_with_a0_sda(i2c, delay);
// let mut tmp = Tmp108::new_with_a0_scl(i2c, delay);
// let mut tmp = Tmp108::new(i2c, delay, A0::Gnd);

let cfg = Default::default()
    .with_cm(ConversionMode::OneShot)
    .with_tm(ThermostatMode::Comparator)
    .with_cr(ConversionRate::Hertz16)
    .with_hysteresis(Hysteresis::FourCelsius)
    .with_polarity(Polarity::ActiveLow);

tmp.set_configuration(cfg)?;

let temp = tmp.temperature()?;

let cfg = cfg
    .with_cm(ConversionMode::OneShot)
    .with_tm(ThermostatMode::Interrupt)
    .with_cr(ConversionRate::Hertz1)
    .with_fl(true)
    .with_fh(true);

tmp.set_configuration(cfg)?;

let high_limit = 48.0;
let low_limit = 26.5;

tmp.set_low_limit(low_limit)?;
tmp.set_high_limit(high_limit)?;

tmp.continuous(Default::default(), |t| {
	for _ in 0..10 {
		let temp = tmp.wait_for_temperature()?;
		info!("Temperature {}", temp);
	}

	Ok(())
})?;

MSRV

Currently, rust 1.79 and up is supported, but some previous versions may work.

License

Licensed under the terms of the MIT license.

Contribution

Unless you explicitly state otherwise, any contribution submitted for inclusion in the work by you shall be licensed under the terms of the MIT license.

License: MIT