Lib.rs

This is a platform agnostic Rust driver the SHT3x (SHT30, SHT31 and SHT35) digital humidity and temperature sensors using the embedded-hal traits.

The device

The sensors of the SHT3x family are humidity and temperature sensors, that are fully calibrated and working with wide range of supply voltages, from 2.15 V to 5.5 V, and using an I²C interface.

They procure fast start-up and measurement times, and great accuracy. The typical accuracies are the following:

The SHT3x is equipped with an internal heater which can increase the temperature in the range of a few degrees centigrade, and that is useful for pausibility checks.

Documentation:

• Datasheet
• Introduction to humidity
• Humidity at a glance
• Arduino driver

Features

• Get the status of the sensor.
• Clear the status of the sensor.
• Enable the internal heater.
• Disable the internal heater.
• Perform a single-shot measurement of temperature and relative humidity.
• Do a sofware set.
• Convert temperatures between °C and °F.
• Calculate the absolute humidity from a measurement.
• Perform periodic measurement of temperature and relative humidity.
• Include a no floating-point variant for systems without fpu.

Usage

To use this driver, import what you need from this crate and an embedded-hal implentation, then instatiate the device.

use embedded_sht3x::{Repeatability::High, Sht3x, DEFAULT_I2C_ADDRESS};
use linux_embedded_hal as hal;

fn main() -> Result<(), embedded_sht3x::Error<hal::I2CError>> {
    // Create the I2C device from the chosen embedded-hal implementation,
    // in this case linux-embedded-hal
    let i2c = match hal::I2cdev::new("/dev/i2c-1") {
        Err(err) => {
            eprintln!("Could not create I2C device: {}", err);
            std::process::exit(1);
        }
        Ok(i2c) => i2c,
    };

    // Create the sensor and configure its repeatability
    let mut sensor = Sht3x::new(i2c, DEFAULT_I2C_ADDRESS, hal::Delay {});
    sensor.repeatability = High;

    // Perform a temperature and humidity measurement
    let measurement = sensor.single_measurement()?;
    println!(
        "Temperature: {:.2} °C, Relative humidity: {:.2} %",
        measurement.temperature, measurement.humidity
    );
    Ok(())
}

License

Licensed under either of

• Apache License, Version 2.0 (LICENSE-APACHE or http://www.apache.org/licenses/LICENSE-2.0)
• MIT license (LICENSE-MIT or http://opensource.org/licenses/MIT)

at your option.

Contribution

Unless you explicitly state otherwise, any contribution intentionally submitted for inclusion in the work by you, as defined in the Apache-2.0 license, shall be dual licensed as above, without any additional terms or conditions.