4 releases (2 breaking)
|new 0.3.1||Jun 23, 2022|
|0.3.0||Jun 14, 2022|
|0.2.0||Mar 13, 2022|
|0.1.0||Dec 24, 2021|
#94 in Hardware support
75 downloads per month
adafruit-itsy-bitsy-rp2040 - Board Support for the Adafruit ItsyBitsy RP2040
You should include this crate if you are writing code that you want to run on an Adafruit ItsyBitsy RP2040 - an RP2040 board in the Itsy family from Adafruit.
This crate includes the rp2040-hal, but also configures each pin of the RP2040 chip according to how it is connected up on the ItsyBitsy RP2040.
To use this crate, your
Cargo.toml file should contain:
adafruit-itsy-bitsy-rp2040 = "0.3.0"
In your program, you will need to call
adafruit_itsy_bitsy_rp2040::Pins::new to create
Pins structure. This will set up all the GPIOs for any on-board
devices. See the examples folder for more details.
To compile an example, clone the rp-hal repository and run:
rp-hal/boards/adafruit-itsy-bitsy-rp2040 $ cargo build --release --example <name>
You will get an ELF file called
./target/thumbv6m-none-eabi/release/examples/<name>, where the
folder is located at the top of the rp-hal repository checkout. Normally
you would also need to specify
--target=thumbv6m-none-eabi but when
building examples from this git repository, that is set as the default.
If you want to convert the ELF file to a UF2 and automatically copy it to the USB drive exported by the RP2040 bootloader, simply boot your board into bootloader mode and run:
rp-hal/boards/adafruit-itsy-bitsy-rp2040 $ cargo run --release --example <name>
If you get an error about not being able to find
$ cargo install elf2uf2-rs, then repeating the `cargo run` command above.
Blink an LED on and off.
Continuously changes the color of the ItsyBitsy's onboard Neopixel.
Contributions are what make the open source community such an amazing place to be learn, inspire, and create. Any contributions you make are greatly appreciated.
The steps are:
- Fork the Project by clicking the 'Fork' button at the top of the page.
- Create your Feature Branch (
git checkout -b feature/AmazingFeature)
- Make some changes to the code or documentation.
- Commit your Changes (
git commit -m 'Add some AmazingFeature')
- Push to the Feature Branch (
git push origin feature/AmazingFeature)
- Create a New Pull Request
- An admin will review the Pull Request and discuss any changes that may be required.
- Once everyone is happy, the Pull Request can be merged by an admin, and your work is part of our project!
The contents of this repository are dual-licensed under the MIT OR Apache
2.0 License. That means you can choose either the MIT license or the
Apache-2.0 license when you re-use this code. See
APACHE2.0 for more
information on each specific license.
Any submissions to this project (e.g. as Pull Requests) must be made available under these terms.